www.fisher-price.comModel Numbers: 79644, B2388PLEASE KEEP FOR FUTURE REFERENCE.Please read these instructions before assembly and use of this product
10Battery Installation Battery Safety Information•Locate the battery compartment door on the swing frame.• Insert a coin into the battery compartment
Securing Your Child11To tighten the restraint:•Feed the anchored end of the waist belt up through thebuckle to form a loop.Pull the free end of the
Adjusting the Seat123UprightReclineAdjust the seat angle in any of three positions:Upright, Semi-Recline or Recline.To adjust the seat angle: Push do
13Baby Sounds ActivatedSpeed DialSwing Mode SwitchPowerL.E.D.Sound Sensitivity DialMusic/Volume SwitchSound Sensitivity Dial•Slide the switch to high
14Parent ActivatedPowerL.E.D.Swing Mode SwitchSpeed DialMusic/Volume Switch14Swing Mode Switch•Slide the switch to parent activated.The power L.E.D.l
Sound ‘n Lights Tray•Fit the sound ‘n lights tray to the tray, as shown.•Baby activates sounds and lights by pulling on the dog orcat; or rolling the
One (1) Year Limited Warranty FCC Statement (United States Only) Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York14052 warrants that Delux
2Warnings and Caution•To prevent serious injury or deathfrom falls and being strangled in therestraint system:- Always use the restraint sys-tem. Neve
3PartsFront BaseRear BaseHousing2 Rear Legs(Shorter)Motor HousingSeat with Restraint2 Seat TubesBracket(with M4 Lock Nuts)Seat Wire2 Seat WireCaps2 Ac
Assembly4124IMPORTANT!Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT useif any parts a
Assembly56578•Pull both rear legs out until they “snap” into place.PullRearLegPullRearLeg•Place the rear base on a flat surface so that the buttons fa
Assembly61091211•Position the bracket so that the tall end is toward thebottom edge of the seat.•Fit the grooves on the bracket to the seat tubes, as
Assembly713141516• Lift the seat tubes slightly.•With the seat wire hanging down, insert the ends of the seatwire through the slots in the seat, as sh
8Assembly17•Position the seat assembly so that the front of the seat istoward the curved front base.•While pressing the buttons on the swing tubes, in
9Assembly21•Fit the bottom edge of the pad around the bottom edge of the seat.• Hook the elastic loops on each side of the pad to the peg on the back
Comments to this Manuals